From crack deflection to lattice vibrations—macro to atomistic examination of dynamic cleavage fracture

A set of cleavage experiments with strip-shaped single-crystal silicon specimens subjected to three-point bending is reported. The experiments enabled examination of the relationships between the dynamic energy release rate, the velocity, the orientation-dependent cleavage energy, and the cleavage plane of propagation.Dynamic crack propagation experiments show that when a [0 0 1] silicon single crystal is fractured under three-point bending at ‘parallel’ velocity (directly measured at the bottom surface of the specimen) of up to , it prefers to cleave along the vertical (1 1 0) plane, while when the specimen is fractured under the same conditions but at a velocity higher than , it cleaves along the inclined (1 1 1) plane. At intermediate velocities, the crack will deflect from the (1 1 0) plane to the (1 1 1) plane. Crack velocity was determined by the initial notch length. The local (calculated) velocity of deflection between the cleavage planes ranges from , for a crack propagating on the (1 1 0) plane in the direction, to about , for a crack on the (1 1 0) plane, but in the [0 0 1] direction.It is suggested that the cause of the deflection phenomenon is the anisotropic, velocity-dependent cleavage energy, resulted phonon radiation caused by anisotropic, velocity-dependent lattice vibrations. We have studied the effect of material properties and propose selection criteria to explain the deflection phenomenon: the crack will deflect to the plane of least-energy, for which G−Γ_i(V)=max, or to the plane with maximum crack tip velocity, V_i(Γ)=max.     

应力波和动光弹等差条纹的分析与判读

介绍了动光弹的基本原理，并从理论上回答了动光弹应用中的一些问题，如惯性力可否忽略等．并在总结回顾动光弹等差条纹级次判读方法的基础上，提出了把应力波理论与等差条纹分析判读相结合的方法，这样不仅使条纹判读的概念更清晰，而且可提高条纹分析和级次判读的准确性．     

Photoelastic model measurement with rotated principal axes by scattered-light photoelasticity

The method of measurement of a three-dimensional photoelastic model with rotated principal axes has not yet been fully experimentally established. It is known that a three-dimensional photoelastic model can be reduced to an optically equivalent model. In this paper, the optically equivalent model is realized from a stratified model consisting of two layers of the frozen stress model. The secondary principal stress direction and the relative phase retardation of the frozen disk model in the stratified frozen stress model are determined for the entire field from Stokes parameters obtained by scattered-light photoelasticity using unpolarized light. The accuracy of these values is confirmed by a comparison with results only from the frozen stress disk model.     

地震作用下基于ADMF和系统参数组合的最优MTMD

多重调谐质量阻尼器 ( MTMD)是由许多频率成线性分布的调谐质量阻尼器组成。可能的系统参数组合形成 5种 MTMD,即 MTMD-1～MTMD-5。基于在基底加速度作用下具有一般 MTMD时结构的加速度传递函数 ,建立了 MTMD-1～ MTMD-5加速度动力放大系数 ( ADMF)的统一模式。利用 ADMF和数值寻优技术进行了详细的最优参数研究。最优参数包括 :最优频率间隔、最优阻尼比、最优调谐频率比。大量的数值比较表明 :在MTMD地震反应控制工程中 ,应优先选择 MTMD-1。     

Intersonic crack propagation in homogeneous media under shear-dominated loading: theoretical analysis

The mechanics of cohesive failure under mixed-mode loading is investigated for the case of a steadily propagating subsonic and intersonic dynamic crack subjected to a follower tensile and shear distributed load. The cohesive failure model chosen in this study is rate independent but accounts for the coupling between normal and tangential damage. Special emphasis is placed here on mixed-mode cases with predominantly shear loading. The analysis shows that the size of the mixed-mode cohesive zone is smaller than that obtained in the pure shear case. The relative extent of the shear and tensile cohesive damage zones depends on the crack speed and the mode mixity. In the intersonic regime, the failure process takes place exclusively in shear, even under remote mixed-mode loading conditions.     

Experimental evidence of energy pumping in acousticsMise en évidence expérimentale de pompage énergétique en acoustique

This Note presents an experimental vibro-acoustic set-up that aims to reproduce the energy pumping phenomenon between an acoustic medium and an essentially nonlinear oscillator. It shows a one-way irreversible transfer of energy between the first acoustic mode in a tube and a thin visco-elastic membrane. To cite this article: B. Cochelin et al., C. R. Mecanique 334 (2006).     

用动态光弹性法研究炮身膛线的脱落问题

本文利用动态光弹性法研究了炮膛膛线脱落的机理。用包含五条膛线的部分炮筒横截面或扇形平面模型,在六种不同的载荷状态下进行了实验。得到了不同载荷状态下,不同瞬时的等差线条纹图的系列照片,以及膛线根部不同瞬时的应力分布曲线。结果表明:当一条或相邻数条膛线顶端受到足够大的均布冲击载荷时,将在承载膛线两侧根部的应力极值点出现膛线脱落的起裂点,而形成八字形脱落;而对非均布的其它几种冲击载荷,膛线都不会出现八字形脱落。     

斜拉桥塔锚固区光弹性应力分析与等倾线图像处理

本文采用光弹性冻结应力法，对独塔斜拉桥塔锚固区进行了应力分析，给出了有关截面的边界应力分布及主应力迹线，从而为优化工程设计提供了重要的参考依据。本文还提出了一种新的提取等倾线的方法──图像对数增强相减法，实现了等倾线与等差线条纹的分离，同时使条纹得到了细化，提高了处理等倾线的速度与准确度。编制了自动绘制主应力迹线的程序，利用它绘制了桥塔截面的次主应力迹线。     

地铁车站地下拱型结构的光弹性应力分析

本文用三维光弹性法，对地铁车站地下拱型结构进行了实验应力分析并绘出主应力迹线。文中还提出对加压用乳胶气囊进行高温、高压预处理工艺，使乳胶气囊和模型曲面很好地吻合，从而提高了加载的准确度。     

应力波传播规律研究中的一种快速分析方法

本文提出了一种能快速、简便、直观地分析了应力波传播状况的方法。该方法利用可视化计算并绘制流前图，而后将其与动光弹条纹图相比较，进而利用所推导的应力波迭加分析式判断出物体边界或其内部的应力波迭加效果。文中对圆盘中的几个典型区域进行了实例分析。